Simulation test of automotive cylinder head for six stroke engine using computer aided engineering software

Click here for a simple search.
[feed] Atom [feed] RSS 1.0 [feed] RSS 2.0
 
 

Mohd Khalidi, Yahya (2009) Simulation test of automotive cylinder head for six stroke engine using computer aided engineering software. Faculty of Mechanical Engineering, Universiti Malaysia Pahang.

[img]
Preview
PDF (Simulation test of automotive cylinder head for six stroke engine using computer aided engineering software - Table of contents) - Accepted Version
105Kb
[img]
Preview
PDF (Simulation test of automotive cylinder head for six stroke engine using computer aided engineering software - Abstract) - Accepted Version
19Kb
[img]
Preview
PDF (Simulation test of automotive cylinder head for six stroke engine using computer aided engineering software - Chapter 1) - Accepted Version
21Kb
[img]
Preview
PDF (Simulation test of automotive cylinder head for six stroke engine using computer aided engineering software - References) - Accepted Version
18Kb

Official URL: http://iportal.ump.edu.my/lib/item?id=chamo:45932&...

Abstract

This dissertation deals with durability assessment for new six-stroke cylinder head engine system using variable pressure loadings. The objective of this dissertation is to develop the general procedures for durability assessment on the cylinder head when the pressure applied. The dissertation describes the finite element analysis techniques to predict the failure of the cylinder head and identify the critical locations of the components. Aluminium 356.0-T71 material was studied in this dissertation which commonly used in automotive industry. The structural three-dimensional solid modelling of cylinder head was developed using the solidwork software. The finite element analysis was then performed using MSC.NASTRAN code. The finite element model of the components was analyzed using the linear statics stress analysis. From the results, it is observed that by making mesh optimization, the accuracy of values for stress and displacement will increase. The obtained results indicate that the values stress for cylinder head is under ultimate tensile strength value of aluminium 356.0-T71.The results concluded that the smallest value of mesh size will produce fine mesh. Based on analysis result, the cylinder head design is acceptable to product by using casting method. The durability assessment results are significant to improve the component design at the early developing stage. The results can also significantly reduce the cost and time to market, and improve product reliability and customer confidence of the component.

Item Type:Undergraduates Project Papers
Additional Information:Project paper ( Bachelor of Mechanical Engineering with Automotive Engineering) -- Universiti Malaysia Pahang - 2009, SV: MR MOHD RASHIDI BIN MAAROF, NO CD: 4468
Uncontrolled Keywords:Cylinders; Automobiles Motors Cylinders
Subjects:T Technology > TA Engineering (General). Civil engineering (General)
ID Code:17378
Deposited By: Ms. Nurezzatul Akmal Salleh
Deposited On:29 Mar 2017 14:26
Last Modified:29 Mar 2017 14:26

Repository Staff Only: item control page

 

 

 

 

 

 

Introduction

An Institutional Repository is an online focus for collecting, preserving, and disseminating any University publication in the digital form for the intellectual sharing.
The UMP Institutional Repository (UMP IR) provides access of University publication such as journal article, conference paper, research paper, thesis and dissertations.


Any Enquiries

Please email or call Knowledge Management staff:-

Pn. Noorul Farina (09-424 5605) OR
Cik Ratna Wilis Haryati (09-424 5612)

Any correspondence concerning this specific repository should be sent to umplibrary@ump.edu.my