Three-Dimensional Morphometric Study of the Trapezium Shape of the Trochlea Tali

Click here for a simple search.
[feed] Atom [feed] RSS 1.0 [feed] RSS 2.0
 
 

Rosdi, Daud and Mohammed Rafiq, Abdul Kadir and Sudin, Izman and Amir Putra, Md Saat and Muhammad Hisyam, Lee and Aminudin, Che Ahmad (2013) Three-Dimensional Morphometric Study of the Trapezium Shape of the Trochlea Tali. The Journal of Foot and Ankle Surgery, 52 . pp. 426-431. ISSN 1067-2516

[img] PDF - Published Version
Restricted to Repository staff only

418Kb

Official URL: http://dx.doi.org/10.1053/j.jfas.2013.03.007

Abstract

The trapezium shape of the talar dome limits the use of 2-dimensional plain radiography for morphometric assessment because only 2 of the 4 required parameters can be measured. We used computed tomography data to measure the 4 morphologic parameters of the trochlea tali: anterior width, posterior width, trochlea tali length, and angle of trapezium shape. A total of 99 subjects underwent computed tomography scanning, and the left and right talus bones were both virtually modeled in 3 dimensions. The 4 morphologic parameters were measured 3 times each to obtain the intraclass correlation, and analysis of variance was used to check for any significant differences between the repeated measurements. The average intraclass correlation coefficient for the measurements for 2 to 3 trials was 0.94 ± 0.04. Statistical analyses were performed on the data from all 198 talus bones using SAS software, comparing male and female and left and right bones. All 4 morphometric values were greater in the male group. No significant differences were found between the left and right talus bones. A strong positive correlation was observed between the trochlea tali length and the anterior width. The angle of trapezium shape showed no correlation with the other 3 parameters. The measurements were compared with the dimensions of the current talar components of 4 total ankle arthroplasty implants. However, most of them did not perfectly match the trapezium shape of the talus from our population. We successfully analyzed the trapezium shape of the trochlea tali using reliable virtual 3-dimensional measurements. Compared with other published reports, our study showed a relatively smaller dimension of the trochlea tali than the European counterparts.

Item Type:Article
Uncontrolled Keywords:ankle; biomechanics; bone; computed tomography; morphometry; tibia; total ankle arthroplasty
Subjects:T Technology > TJ Mechanical engineering and machinery
Divisions:Faculty of Mechanical Engineering
ID Code:7039
Deposited By: Mrs. Neng Sury Sulaiman
Deposited On:18 Dec 2014 10:33
Last Modified:19 Jan 2018 10:16

Repository Staff Only: item control page

 

 

 

 

 

 

Introduction

An Institutional Repository is an online focus for collecting, preserving, and disseminating any University publication in the digital form for the intellectual sharing.
The UMP Institutional Repository (UMP IR) provides access of University publication such as journal article, conference paper, research paper, thesis and dissertations.


Any Enquiries

Please email or call Knowledge Management staff:-

Pn. Noorul Farina (09-424 5605) OR
Cik Ratna Wilis Haryati (09-424 5612)

Any correspondence concerning this specific repository should be sent to umplibrary@ump.edu.my