Study of Flow and Temperature Effect on Carbon Steel in Oil and Gas Environment

Click here for a simple search.
[feed] Atom [feed] RSS 1.0 [feed] RSS 2.0
 
 

R., Daud and N. Zara, Kolan and Mas Ayu, Hassan and Siti Haryani, Tomadi and Sudin, Izman (2015) Study of Flow and Temperature Effect on Carbon Steel in Oil and Gas Environment. In: 4th International Conference on Advanced Manufacturing Technology (ICAMT 2015), 19-22 Sept 2015 , Johor Bahru. . (Unpublished)

[img] PDF
Restricted to Repository staff only

12Mb

Abstract

The effect of flow rate and temperature are believed to contribute in corrosion rate of carbon steel with presence of CO2 in oil and gas environment. The aim of the study are to investigate the effect of temperature and fluid flow rate on corrosion rate which focus on the formation of protective layer (FeCO3) on carbon steel. In this experiment, the specimen used is carbon steel (AISI 1045) and it is grinded with sand paper of 180, 280 and 400 grit on the surface of carbon steel. The specimen was tested with 3.5% NaCl and pH 4 with different temperature of 250C, 500C and 800C. The fluid flow rate is varied by different rate of rotation which is 0 rpm, 500 rpm, 1000 rpm and 2000 rpm with the injection of saturated CO2. Linear Polarization Resistance (LPR) is used to measure the corrosion rate and the formation of protective layer is observed under Field Emission Scanning Electron Microscopy (FESEM) and Energy-dispersive X-ray Spectroscopy (EDX). The effect of flow rate and temperature seems influence the corrosion rate significantly. While the flow rate 2000 rpm shows the highest corrosion rate due to its turbulence pattern of the fluid flowing and enhanced the corrosion to occur. The scaling temperature obtain in this investigation is 500C since at this point the corrosion rate seems to be the highest. This is due to the formation of porous and non-protective FeCO3 layer on the wall of carbon steel. While, at 800C the corrosion rate drops due to the formation of a dense protective layer. It is can be concluded that the scaling temperature is occurred at 500C and started to decrease at 800C. This finding shows that corrosion at maximum rate will occur faster than reported by previous study which the maximum corrosion rate occurred only at above 600C.

Item Type:Conference or Workshop Item (Lecture)
Uncontrolled Keywords:Flow and temperature effect, carbon steel, FeCO3 protective layer, oil and gas environment, CO2 corrosion.
Subjects:T Technology > TJ Mechanical engineering and machinery
Divisions:Faculty of Mechanical Engineering
ID Code:10557
Deposited By: Mrs. Neng Sury Sulaiman
Deposited On:30 Sep 2015 12:04
Last Modified:31 Jan 2018 15:20

Repository Staff Only: item control page

 

 

 

 

 

 

Introduction

An Institutional Repository is an online focus for collecting, preserving, and disseminating any University publication in the digital form for the intellectual sharing.
The UMP Institutional Repository (UMP IR) provides access of University publication such as journal article, conference paper, research paper, thesis and dissertations.


Any Enquiries

Please email or call Knowledge Management staff:-

Pn. Noorul Farina (09-424 5605) OR
Cik Ratna Wilis Haryati (09-424 5612)

Any correspondence concerning this specific repository should be sent to umplibrary@ump.edu.my