Analysis the effect of different type valve use at different pressure in piping system

Click here for a simple search.
[feed] Atom [feed] RSS 1.0 [feed] RSS 2.0
 
 

Muzakkir, Shukri (2010) Analysis the effect of different type valve use at different pressure in piping system. Faculty of Mechanical Engineering, Universiti Malaysia Pahang.

[img]
Preview
PDF
468Kb

Official URL: http://iportal.ump.edu.my/lib/item?id=chamo:51871&...

Abstract

This project was carried out as a study of flow rate using a single channel acoustic emission (AE) technique. The objective of this project is to study the effect of ball valve, brass gate valve and brass stop cock valve to flow rate using AE technique. A test rig consists of the circumferential galvanized steel pipe, ball valve, gate valve and stop cock valve to run the experiments. The fluid used was water throughout the experiments. The pressure of water was controlled by a valve. The source of AE signal was from the valve and it was captured using AE sensor with the help of Acoustic Emission Detector 2.1.3 software. For all valve conditions, the value of hits, count and RMS (average, maximum and minimum) were recorded and analyzed. All the value recorded were compared among the ball valve, gate valve and stop cock valve. The results were gained from 10 marked points each for all type of valve. The result showed that there was no AE activity on the pipe without valve, the AE activities are greater for high pressure or full close valve. In addition from the RMS against distance graft, RMS value increased when pressure is increased. From the flow rate against RMS graf show that flow rate will decrease when RMS is increased.

Item Type:Undergraduates Project Papers
Uncontrolled Keywords:Accoustic emission, Accoustic emission testing, Valves, Piping
Subjects:T Technology > TA Engineering (General). Civil engineering (General)
Divisions:Faculty of Mechanical Engineering
ID Code:1729
Deposited By: Syed Mohd Faiz
Deposited On:02 Aug 2011 12:40
Last Modified:03 Mar 2015 15:52

Repository Staff Only: item control page

 

 

 

 

 

 

Introduction

An Institutional Repository is an online focus for collecting, preserving, and disseminating any University publication in the digital form for the intellectual sharing.
The UMP Institutional Repository (UMP IR) provides access of University publication such as journal article, conference paper, research paper, thesis and dissertations.


Any Enquiries

Please email or call Knowledge Management staff:-

Pn. Noorul Farina (09-424 5605) OR
Cik Ratna Wilis Haryati (09-424 5612)

Any correspondence concerning this specific repository should be sent to umplibrary@ump.edu.my