Surface Roughness Analysis on Sheet Metals During AWJ Machining Using Low Pressure

Nazrin, Mokhtar and Asmelash, Mebrahitom and Saptaji, Kushendarsyah and Azmir, Azhari (2023) Surface Roughness Analysis on Sheet Metals During AWJ Machining Using Low Pressure. In: International Manufacturing Engineering Conference & The Asia Pacific Conference on Manufacturing Systems , 27-28 October 2022 , Surakarta, Indonesia. pp. 59-64.. ISSN 2195-4356 ISBN 978-981-99-1244-5

Preview	Pdf Surface Roughness Analysis on Sheet Metals.pdf Download (529kB) | Preview
	Pdf Surface Roughness Analysis on Sheet Metals During AWJ Machining Using Low Pressure.pdf Restricted to Repository staff only Download (278kB) | Request a copy

Abstract

The present study discusses the effect of abrasive waterjet machining (AWJ) parameters on surface roughness during cutting of sheets metals of stainless steel 304 and pure copper. A relatively low hydraulic pressure below 150 MPa was used. Several machining parameters were chosen namely pressure, traverse rate, stand-off distance and abrasive mass flowrate. It was found that increasing the pressure leads to an increase in the surface roughness. Varying other parameters did not clearly show any trends on the surface roughness. A higher surface roughness happened during AWJ machining of stainless steel 304 compared to pure copper due to its former higher hardness. The surface roughness at the upper region closer to the top surface is higher than the bottom section regardless of machining parameters. Furthermore, embedded particles are more dominant in pure copper than stainless steels 304. It can be concluded that a low water pressure in AWJ machining process can be used to cut sheet metals successfully with acceptable cutting quality.

Item Type:	Conference or Workshop Item (Paper)
Uncontrolled Keywords:	Abrasive waterjet machining; Sheet metals; Surface roughness
Subjects:	T Technology > TA Engineering (General). Civil engineering (General) T Technology > TS Manufactures
Faculty/Division:	Institute of Postgraduate Studies Faculty of Manufacturing and Mechatronic Engineering Technology
Depositing User:	Miss Amelia Binti Hasan
Date Deposited:	04 Oct 2023 07:13
Last Modified:	04 Oct 2023 07:13
URI:	http://umpir.ump.edu.my/id/eprint/38802
Download Statistic:	View Download Statistics

Actions (login required)

View Item