UMP Institutional Repository

Items where Division is "Faculty of Chemical & Natural Resources Engineering" and Year is 2011

Up a level
Export as [feed] Atom [feed] RSS 1.0 [feed] RSS 2.0
Group by: Authors | Item Type | No Grouping
Jump to: A | C | D | E | H | I | J | K | L | M | N | P | S | T | Z
Number of items: 53.

A

Abdullah, Luqman Chuah and Jolius, Gimbun and Fakhru'l-Razi, A. and Sahari, Barkawi and Thomas, S. Y. Choong (2011) Prediction of CO and NOx Abatement in Catalytic Converter of a Compressed Natural Gas Vehicle (CNGV) Cold-Start Engine. In: Advances in Environmental Research. Nova Science Publishers , New York, United States, pp. 75-90. ISBN 978-1-61209-975-0

Ahmad Khairul Azhar, Ahmad Kamal (2011) Sustainability approach in modeling and improvement of finger type slug catcher in gas processing plant. Faculty of Chemical & Natural Resource Engineering, Universiti Malaysia Pahang.

Ahmad Ziad, Sulaiman and Azilah, Ajit and R. M., Yunus and Chisti, Yusuf (2011) Ultrasound-assisted fermentation enhances bioethanol productivity. Biochemical Engineering Journal. pp. 141-150.

Ambarwati, Dessy (2011) Characterization and process optimization of Melastoma malabathricum l. extract. Masters thesis, Universiti Malaysia Pahang.

Asdarina, Yahya (2011) Kajian terhadap pelbagai teknik pengekstrakan minyak pati dari tanaman nilam (pogostemon cablin benth). Masters thesis, Universiti Malaysia Pahang.

Azizan, Ramli and Mohd Shaiful Zaidi, Mat Desa (2011) The Importance of Ecological and Spiritual Approaches in Chemical Engineering towards Practical Conception of Sustainable Development. In: The Inaugural Asian Conference on Sustainability, Energy and the Environment 2011, 2-5 Jun , Osaka, Japan. .

C

C. K. M., Faizal and Mohib Reza, Kazimi and Iqbal, Ahmed (2011) A Short Review of Hydrophilic Surface Modification Methods for Low Density Poly Ethylene. In: International Conference on Chemical Innovation (ICCI 2011), 23-24 May 2011 , TATI University College. pp. 203-206..

C. K. M., Faizal and Shareena, Mohd Sharif (2011) Application of Factorial Design Analysis to Control Bisphenol A MIP fabrication. In: Proceeding of International Conference Of Chemical Engineering And Industrial Biotechnology In Conjunction With 25th Symposium Of Malaysian Chemical Engineer (ICCEIB-Somche) 2011, 28 November - 1 December 2011 , Kuantan, Pahang. pp. 1-6..

Cheng, Hock Tian (2011) Engineering Properties of Epoxy Polymer Cement Concrete Reinforced with Glass Fibers. Journal of Engineering and Applied Sciences, 6 (3). pp. 191-199. ISSN 1816-949X

Chin, S. Y. and Radzi, S. N. R. and Maharon, I. H. and Shafawi, M. A. (2011) Kinetic Model and Simulation Analysis for Propane Dehydrogenation in an Industrial Moving Bed Reactor. World Academy of Science, Engineering and Technology, 76 (34). pp. 183-189. ISSN 2010-3778

D

Ding, Gong Tao (2011) The optimisation and scale-up of microalgae cultivation for high level oil content for biodiesel. Masters thesis, Universiti Malaysia Pahang.

E

Erna Qurratu' Aini, Ruslan (2011) Study on extraction of pandan flavor from pandan leaves using steam distillation. Faculty of Chemical & Natural Resources Engineering, Universiti Malaysia Pahang.

H

Hamad Khudhair, Mohammed (2011) Performance of cocoa husk mucilage as a drag reduction agent in pipes. Masters thesis, Universiti Malaysia Pahang.

Hernawati, Lahading (2011) Development of chitosan based adsorbent for the removal of residual oil from palm oil mill effluent (POME). Masters thesis, Universiti Malaysia Pahang .

I

Izirwan, Izhab and Siti Zubaidah, Sulaiman and Mohd Zulkifli, Mohamad Noor (2011) Effect Of H2 Enrichment On The Explosive Limits Of Liquefied Petroleum Gas (LPG) In Conventional Combustion. In: Energy and Sustainability 2011, 11-13 April 2011 , Alicante, Spain. . (Unpublished)

J

Jolius, Gimbun and Mohd Irwan Shah, Md Zain (2011) CFD Study On The Performance Of Oxygen Lance For Partial Combustion Unit At Direct Reduction Plant. In: Internation Conference on Chemical Innovation, 23-24 May 2011 , TATI UC. pp. 1-4.. (Unpublished)

Juwari (2011) A new tuning method for two-degree-of-freedom internal model control under parametric uncertainty. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

K

Khairatun Najwa, Mohd Amin and Nurul Sa'aadah, Sulaiman and Muhammad Shahir, Hasan and Ainun Jariah, Sansuri (2011) Synthesis And Swelling Behavior Of Agro-Waste Based Superabsorbent Composites. In: 5th International Congress of Chemistry and Environment (ICCE 2011), 27-29 May 2011 , Port Dickson. pp. 1-5.. (Unpublished)

L

Leakath, Muhammad Zafran (2011) Characterization of pysio-chemical properties of novel one stop chemical method in preparations of copper nanofluids and possible explanations. Faculty of Chemical & Natural Resources Engineering, Universiti Malaysia Pahang.

M

Mimi Sakinah, A. M. and Noor Suhana, Adzahar (2011) Application of Fractional Factorial Design (FFD) for Screening of Significant Factor in Influencing Succinic acid Production from Biodiesel Based Glycerol Using Escherichia Coli. In: 4th International Conference on Modeling, Simulation and Applied Optimization (ICMSAO) 2011, 19-21 April 2011 , Kuala Lumpur. pp. 1-5..

Mohammad Razif, Abdul Rahman (2011) Investigating the effect of solid powder particle size on the turbulent multi-phase flow in pipelines. Faculty of Chemical & Natural Resource Engineering, Universiti Malaysia Pahang.

Mohd Faizan, Jamaluddin and Jailani, Salihon and N., Zainol (2011) Factorial Analysis on Acetic Acid Production Using Banana Stem Waste. International Journal of Chemical and Environmental Engineering.

Mohd Hafiz, Ab Majid @ Aziz (2011) Glucose production from oil palm trunk. Faculty of Chemical and Natural Resources Engineering , Universiti Malaysia Pahang .

Mohd Najib, Razali (2011) Adsorption treatment of monoethanolamine (MEA) wastewater from oil and gas industry. Masters thesis, Universiti Malaysia Pahang .

Mohd Shahimie, Selamat and Jolius, Gimbun (2011) CFD Study of Gas-liquid Hydrodynamics in a Bubble Column. Jurnal UMP - Kejuruteraan & Sains Komputer, 4. pp. 77-88. ISSN 1985-5176

Mohd Syahrul Ridhwan, Abdullah (2011) Optimization of glycerol recovery on effect of waste volume and ph using response surface methodology (RSM). Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

Muhammad Ridzuan, Kamaruzaman (2011) Isolation of microorganism from oil palm-sap. Faculty of Chemical & Natural Resources Engineering, University Malaysia Pahang.

N

N., Zainol (2011) Screening of Factors Affecting Biological Delignification Process of Oil Palm Trunk Using Local Oyster Mushroom (Pleurotus Ostretus). International Journal of Chemical and Environmental Engineering , 2 (4). ISSN 20780737

Nallappan, Madana Leela (2011) Development of virgin polypropylene composite by sugarcane bagasse reinforcement. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

Noor Intan Shafinas, Muhammad (2011) Computational fluid dynamics of industrial scale spray dryer. Masters thesis, Universiti Malaysia Pahang.

Nor Ilia Anisa, Aris (2011) Demulsification of water-in- oil (W/O) emulsion by microwave heating technology. Masters thesis, Universiti Malaysia Pahang .

Nor Izzatiey, Mohammad Usolli (2011) The effect of adsorbent additive on clay based adsorbent to the removal of multidye system. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

Nor Khonisah, Daud and B. H., Hameed and Nurul Sa'aadah, Sulaiman (2011) Fenton-like oxidation of reactive black 5 solution using Fe-rice husk ash catalyst. In: UNSPECIFIED . . (Unpublished)

Nora'asheera, Mohd Nazif (2011) Composites from polypropylene (PP) reinforced with oil palm empty fruit bunch (OPENFB) fibre. Faculty of Chemical and Natural Resources Engineering , University Malaysia Pahang.

Norasiha, Hamid (2011) Inclusion complex formation between natural dye extracted from pitaya fruit skin and β-cyclodextrin : kinetic and thermodynamic study. Masters thesis, UNIVERSITI MALAYSIA PAHANG .

Norshahida, Rahman (2011) Feasibility study of LNG pre � cooling system using carbon Dioxide as a refrigerant. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

Nur Asilah, Che Aziz (2011) Mechanical performance of kenaf fibre reinforced thermoplastic composite. Faculty of Chemical Engineering and Natural Resources, University Malaysia Pahang.

Nur Hayati, Zulkefli (2011) Preparation and characterization of cobalt based and zinc promoted catalyst fro fisher tropsch synthesis. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

Nur Syazwani, Ghazali (2011) Extraction of Pandanus Amaryllifolius essential oil from pandan leaves. Faculty of Chemical & Natural Resources Engineering, Universiti Malaysia Pahang.

Nur Syuhada, Omar (2011) Removal of heavy metal in medical institutional wastewater using ultrasonic assisted various leaching solution. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

Nurul Nadia Ummira, Abu Bakar (2011) Isolation of microorganism from oil palm sap. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

P

Paveswari, Sithambaranathan (2011) Production of plastic from marine algae. Faculty of Chemical & Natural Resources Engineering, Universiti Malaysia Pahang.

Prakash, Gunah (2011) Optimization of xylose production from sugarcane bagasse using response surface methodology (RSM). Faculty of Chemical and Natural Resources Engineering , Universiti Malaysia Pahang .

S

Sanggie, Florence Wednna (2011) Process modeling and comparison study of acid gas removal unit by using different aqueous amines. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

Shakaib, M. and R. M., Yunus (2011) Effect of Permeation Velocity on Flow Behavior and Pressure Drop in Feed Channels of Membranes. In: ASEAN Conference on Scientific and Social Science Research (ACSSSR2011), 01 Jul 2011 . . (Unpublished)

Sharifah Zureehan, Syed Othman (2011) An experimental study on LPG/H2O2 mixture for combustion. Faculty of Chemical & Natural Resources Engineering, Universiti Malaysia Pahang.

Sita Fitriana, (2011) Efficient direct regeneration of true-to-type Pogostemon cablin benth from leaf explant and profile of essential oils. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

Siti Nor Fazruaini, Rusli (2011) Extraction and characterization of Malaysia pandan leaves by soxhlet method. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang .

Sri Murni, Astuti (2011) Optimization process of binahong extraction and characterization study. Masters thesis, Universiti Malaysia Pahang.

Suryanarayana, K. V. and Rao, G. Srinivasa and Prasad, D. M. R. and Sharma, K. V. and Sarma, P. K. (2011) Experimental Analysis of Heat and Mass Transfer in a Packed Bed. Journal of Mechanical Engineering and Sciences (JMES) , 1. pp. 124-132. ISSN 2289-4659 (print); 2231-8380 (online)

Syed Ahmad Farhan , Syed Ab Mutalib (2011) Modeling of single mixed refrigerant process for offshore natural gas liquefaction. Faculty of Chemical & Natural Resource Engineering, Universiti Malaysia Pahang.

T

Thaomadaran, Ghunavathy (2011) Composite of the recycled polypropylene reinforced with oil palm empty fruit bunch. Faculty of Chemical & Natural Resources Engineering , Universiti Malaysia Pahang.

Z

Zainatul Bahiyah , Handani (2011) A Mixed Integer Linear Programming (MILP) Model for Optimal Design of Water Network. In: 4th International Conference on Modelling, Simulation and Applied Optimization, 19-21 April 2011 , Impiana KLCC Hotel & Spa Kuala Lumpur.. pp. 1-6..

This list was generated on Sun Apr 21 12:23:59 2019 +08.